diff --git a/Setup-Documentation.md b/Setup-Documentation.md
index 650e02f..59802e2 100644
--- a/Setup-Documentation.md
+++ b/Setup-Documentation.md
@@ -126,7 +126,7 @@ Home all axes and then enter <code>PROBE_CALIBRATE</code> into the command line.
 
 Once the Z offset is set, you can now manually level the be by entering <code>BED_SCREWS_ADJUST</code> into the command line. The machine will then go to each corner one-by-one while you adjust the screw knobs and repeat the paper test, like in the Z offset section. If you need to make an adjustment to the screw (more than 1/8 of a turn), click "Adjustment", if the setting is fine, click "Accept" - once you accept all four corners in a row, the bed is leveled.
 
-## Bed Mesh Calibration
+### Bed Mesh Calibration
 [Official documentation link](https://www.klipper3d.org/Bed_Mesh.html)
 
 **NOTE:** I'm not certain this is 100% necessary as this unit appears to have a pretty dang flat bed; my results have not been much different when using a bed mesh. I feel that the BL Touch probe installed is either wonky or inaccurate. If and when I switch this machine over to hard mounts, this may be a more important set.