diff --git a/Setup-Documentation.md b/Setup-Documentation.md
index 0e55de0..78354e6 100644
--- a/Setup-Documentation.md
+++ b/Setup-Documentation.md
@@ -1,4 +1,3 @@
-
 # Hardware
 ## Specs
 **BTT SKR Mini E3 V2.0, direct drive, and BL-Touch - Raspberry Pi 4 running Klipper & Fluidd**
@@ -132,3 +131,16 @@ Once the Z offset is set, you can now manually level the be by entering <code>BE
 
 **NOTE:** I'm not certain this is 100% necessary as this unit appears to have a pretty dang flat bed; my results have not been much different when using a bed mesh. I feel that the BL Touch probe installed is either wonky or inaccurate. If and when I switch this machine over to hard mounts, this may be a more important set.
 
+### ...and the rest.
+These are things that need to be set up but not done as frequently. 
+
+#### Pressure Advance
+[Official documentation link](https://www.klipper3d.org/Pressure_Advance.html)
+
+Most guides say to run this for every filiment you use. I use the same pressure advance settings for each *type* of filament -- PLA, PETG, ABS, etc. 
+
+#### Resonance Compensation
+[Official documentation link](https://www.klipper3d.org/Resonance_Compensation.html)
+
+From what I've read (and my experience), this really only needs to be done if the mass of the printhead changes (like replacing the direct drive motor, changing the probe, or installing a new hotend). As this was a from-scratch setup, I already went ahead and ran it. It might be a good idea to just calibrate once every few months, but honestly I'm not certain how necessary it is. 
+