diff --git a/Extreme Networks WS-AP3825I - How to flash with OpenWRT.-.md b/Extreme Networks WS-AP3825I - How to flash with OpenWRT.-.md
new file mode 100644
index 0000000..dbfe919
--- /dev/null
+++ b/Extreme Networks WS-AP3825I - How to flash with OpenWRT.-.md	
@@ -0,0 +1,54 @@
+# OpenWRT Access Points
+These units are compatible with OpenWRT and therefore a much better solution than the Ruckus R700 units I have that are extremely out of date. Currently, this guide is primarily just copy-pasted from a Reddit post, as I do not yet have the access points, but from what I've read it seems like it should work just fine. 
+
+## Flashing process
+
+### Before you begin
+First, we'll need a Cisco-compatible serial cable (RJ45 to USB).  For simplicity's sake, go ahead and perform a factory reset on these before starting. **However, let it boot up once normally before beginning!**
+
+### The process
+1.  Plug in the USB end of the serial cable. We want to open a terminal on ttyUSB0, (or whichever ttyUSB* device is available.
+ ```<sh>
+sudo picocom -b 115200 /dev/ttyUSB0
+```
+
+2. Once we know that we can see the cable, go ahead and power up the AP and connect the RJ45 end of the serial cable to the LAN1 port (**NOT** LAN2).
+
+3. At this point, the `picocom` terminal should prompt for a login. Use `admin` for the username and `new2day` for the password.
+
+4. In a new terminal window, create a temporary directory and move into it with 
+```<sh>
+cd $(mktemp -d)
+``` 
+
+5. Still in the new terminal window, download the firmware image, 
+```
+curl https://downloads.openwrt.org/releases/23.05.5/targets/mpc85xx/p1020/openwrt-23.05.5-mpc85xx-p1020-extreme-networks_ws-ap3825i-initramfs-kernel.bin -o ws-ap3825i-initramfs.bin
+```
+
+6. Finally, in that same new terminal window, start a TFTP server using 
+```
+sudo dnsmasq -d --enable-tftp --port 0 --tftp-root $(pwd)
+```
+
+7. In the original TTYUSB0 terminal, run the following commands, being sure to enter the correct IP address for the TFTP server (the computer you're using) and the AP.
+
+```
+setenv ramboot_openwrt "setenv ipaddr <server_ip>; setenv serverip <access_point_ip>; tftpboot 0x2000000 ws-ap3825i-initramfs.bin; interrupts off; bootm start 0x2000000; bootm loados; fdt resize; fdt boardsetup; fdt resize; fdt boardsetup; fdt chosen; fdt resize; fdt chosen; bootm prep; bootm go;"
+```
+
+```
+setenv boot_openwrt "cp.b 0xEC000000 0x2000000 0x2000000; interrupts off; bootm start 0x2000000; bootm loados; fdt resize; fdt boardsetup; fdt resize; fdt boardsetup; fdt chosen; fdt resize; fdt chosen; bootm prep; bootm go;"
+```
+
+```
+setenv bootcmd "run boot_openwrt";
+```
+
+```
+saveenv
+````
+
+```
+run ramboot_openwrt 
+```
\ No newline at end of file